ELECTRICAL SYSTEM 16-61
Meter
•
Cycle the meter to TRIP A or TRIP B mode.
•
Check that when the SET/RESET button [A] is pushed,
the display turns to 0.0.
If this display function does not indicate 0.0 [B], replace
the meter unit.
•
Check that when the TIME SET [A] and SET/RESET [B]
buttons are pushed, the time [C] will reset.
If the meter function does not work, replace the meter unit.
Check 3: Speedometer Check
•
Connect the wires in the same manner as Check 1.
•
The speed equivalent to the input frequency is indicated in
the oscillator [A], if the square wave is input into terminal
[1].
○
Indicates approximately 40 mph if the input frequency is
approximately 789 Hz.
○
Indicates approximately 40 km/h if the input frequency is
approximately 526 Hz.
If the meter function does not work, replace the meter unit.
Check 4: Odometer Check
•
Connect the wires in the same manner as Check 3.
•
Pushing the MODE button [A], cycles the odometer [B].
•
Raise the input frequency of the oscillator to see the result
of this inspection.
If the value indicated by the odometer does not work, re-
place the meter unit.
Kommentare zu diesen Handbüchern