11-30 F INAL DRIVE
Front A xle
•
Remove the steel balls [A].
•
Slide the cage [B] toward the center of the axle.
•
Tap the inner race [A] straight with a plastic hammer until
it is locked by the circlip.
•
Remove the inboard joint boot.
Inboard Joint Boot Installation
•
Wind the tape on the splines of the axle shaft in order to
protect the joint boot.
•
Install:
New Small Band [A]
New Inboard Joint Boot [B]
Cage [C]
Circlip [D]
•
Install the inner race [A] so that the stepped side [B] faces
front final gear case.
•
Press the inner race [A] using the rotor puller [B] (57001
-1216) until it is bottomed.
Special Tool - Rotor Puller, M16/M18/M20/M22 × 1.5: 57001
-1216
Kommentare zu diesen Handbüchern