DR ALL-TERRAIN Wartungshandbuch PDF herunterladen (Seite 311)

100

101

WHEELS/TIRES 10-7

Wheel Ali gnment

•

Repeat the straightedge procedure on the other side of

the vehicle. Now the front wheels are parallel to each

other and to the center line of the vehicle.

Front Wheel [A]

Vehicle Center Line [B]

Parallel each other [C]

Straightedges [D]

Rear Wheels [E]

•

Go on to the Toe-in Inspection procedure.

Toe-in Inspection

•

Apply a heavy coat of chalk or a paint line near the center

of the front tires.

•

Using a needle nose scriber, make a thin mark near the

center of the chalk coating while turning the wheel.

•

With the front wheels on the ground, set the handlebar

straight ahead.

•

At the level of the axle height, measure the distance be-

tween the scribed or painted lines for both front and rear

of the front tires.

•

Subtract the measurement of the front from the measure-

ment of the rear to get the toe-in.

If the toe-in is not in the specified range, go on to the

Toe-in Adjustment procedure.

Toe-in of Front Wheels

Standard: –10 ∼ 10 mm (–0.39 ∼ 0.39 in.) at 1G

Toe-in Adjustment

•

Loosen the locknuts [A] [B] and turn the tie-rod [C] the

same number of turns on both sides to achieve the spec-

ified toe-in.

NOTE

○

The locknut [B] near the L mark [D] on the tie-rod has

left-hand threads. Turn the locknut clockwise for loos-

ening.

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 593 594

Kommentare zu diesen Handbüchern

Keine Kommentare

DR ALL-TERRAIN Wartungshandbuch Seite 311

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rasenmäher DR ALL-TERRAIN