16-28 ELECTRICAL SYSTEM
Charging System
•
Check that the bearing [A] is in place.
•
Fit the grommets [A] into the notch in the cover.
•
Grease the alternator cover o il seal.
•
Tighten:
Torque - Alternator Cov er Bolts: 8. 8 N·m (0.90 kgf ·m, 78
in·lb)
•
Check that the O-ring [A] i n the collar [B] is in good con-
dition.
•
Apply grease to the O-ring.
•
Install the collar on the alternator cover.
•
Hold the drive pulley with the drive pulley holder [A].
Special Tool - Drive Pulley Holder: 57001-1520
•
Install the collar [A] to the crankshaft.
•
Tighten:
Torque - Alternator Rotor Bolt [B]: 127 N·m (13 kgf·m, 94
ft·lb)
•
Install the removed parts (see appropriate chapter).
•
Pour:
Coolant (see Coolant Change in the Periodic Mainte-
nance chapter)
Engine Oil (see Engine Oil Change in the Periodic Main-
tenance chapter)
Kommentare zu diesen Handbüchern