DR PRO Betriebsanleitung PDF herunterladen (Seite 34)

30 16.50 PRO DR

RAPID-FEED™ CHIPPER

Grease Fittings

Your RAPID-FEED CHIPPER was greased at the Factory. The operator needs to periodically lubricate the

two Bearings of the Chipper Assembly.

Tools and Supplies needed:

• Flexible hose grease gun

• Lithium grease

• Clean cloth

• 5/32" Allen Wrench

• Loctite

243

1. Remove the Belt Cover (see “Removing, Replacing and

Adjusting the Drive Belt” in this Chapter).

2. Wipe all dirt, etc., from the grease fittings with a clean

cloth (Figure 24).

3. Apply no more than three pumps of quality general-

purpose lithium grease with a hand-pumped grease

gun to each Bearing Grease Fitting, one on either side

of the Chipper Assembly.

4. Check the Set Screws for tightness. If they are not tight

they should be removed, apply Loctite

to the threads,

then reinstall and tighten the Set Screws.

5. Replace the Belt Guard.

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE

SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE

PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.

Bearing

Set

Screw

Grease

Fitting

Bearing

Front Chipper Bearing

Grease

Fitting

Set

Screw

Rear Chipper Bearing (under Belt Cover)

Figure 24

OVER LUBRICATION CAN DAMAGE THE BEARINGS.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

Keine Kommentare

DR PRO Betriebsanleitung Seite 34