DR PRO Betriebsanleitung PDF herunterladen (Seite 51)

CHAPTER 6

TROUBLESHOOTING

Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and

their solutions. If you continue to experience problems, contact us at www.DRpower.com or call DR

Power Equipment for support.

Troubleshooting Table

SYMPTOM POSSIBLE CAUSE

The engine won’t start

using electric-start.

(Please refer to the

Engine Owner’s

manual for engine-

specific procedures.)

⇒ Is the Fuel Shut-Off Valve in the ON position?

⇒ Is the spark plug wire attached?

⇒ Have you checked all the items under the section called Electric

Starting in Chapter 4?

⇒ Check the wire connections, especially the large black ground wire

where it connects to the battery and where it connects to the engine.

⇒ Check the wire connections to the solenoid. Disconnect the black

battery ground wire first to avoid sparks. Check to be sure that all of

the connections are clean and tight. Reconnect the battery ground

wire.

⇒ Check the ground connection on the solenoid where it’s bolted to the

frame. Using a wrench or socket, tighten the bolts to ensure a good

connection to the frame.

⇒ Is your battery charged? Check the voltage yourself or at a service

station. If it’s low, charge it with a 12-volt, 1 to 2 Amp trickle charger.

If you don’t use your Chipper for at least 45 minutes at a time, the

battery may need to be periodically charged. See the Battery Care

section in Chapter 5.

⇒ If your battery is charged and your DR RAPID-FEED CHIPPER still

won’t start, contact us at www.DRpower.com or call 1(800) DR-

OWNER (376-9637) for assistance.

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,

REMOVE SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER..

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Keine Kommentare

DR PRO Betriebsanleitung Seite 51