DR PRO Betriebsanleitung PDF herunterladen (Seite 46)

42 16.50 PRO DR

RAPID-FEED™ CHIPPER

The Clutch obtains its power from the Engine RPM. The lower the engagement speed, and the higher

the maintained Engine speed, the more torque the Clutch can transfer to the driven unit. NEVER

operate the DR RAPID-FEED CHIPPER Engine at less than full RPM when chipping.

NOTE: At engine start-up, the engine of your chipper operates under no load until approximately 1800 RPM,

at which speed the centrifugal clutch engages and begins driving the rotor. Proper engine speed for

chipping is 3400-RPM +/- 200 RPM.

Installing a new Clutch Assembly

NOTE: If a Clutch part malfunctions, it could jeopardize the integrity of other Clutch components. If you have

problems with the Clutch, a Clutch Kit is available, but we recommend replacing your Clutch as a

complete assembly.

• DO NOT TAMPER WITH THE ENGINE’S GOVERNOR SETTING. THE GOVERNOR CONTROLS THE

MAXIMUM SAFE OPERATION SPEED AND PROTECTS THE ENGINE. OVER-SPEEDING THE

ENGINE IS DANGEROUS AND WILL CAUSE DAMAGE TO THE ENGINE AND TO THE OTHER

MOVING PARTS OF THE MACHINE. SEE YOUR AUTHORIZED DEALER FOR ANY ENGINE

GOVERNOR ADJUSTMENTS.

• BECOME FAMILIAR WITH SUCCESSFUL OPERATING CONDITIONS AND AVOID THOSE THAT CAN

OVERLOAD AND DAMAGE THE MACHINE.

• DO NOT OVERLOAD OR ATTEMPT TO CHIP MATERIAL BEYOND MANUFACTURERS

RECOMMENDATION. PERSONAL INJURY OR DAMAGE TO THE MACHINE COULD RESULT.

LEARN TO RECOGNIZE THE SOUND OF THE MACHINE DURING AN OVERLOAD CONDITION.

ONLY YOUR OPERATOR EXPERIENCE WILL TELL YOU HOW FAST YOU CAN SUCCESSFULLY FEED

MATERIAL INTO THE MACHINE.

• IF OVERLOADING OR ANY OTHER CAUSE JAMS THE MACHINE, STOP THE MACHINE

IMMEDIATELY. IF YOU JAM THE MACHINE AND DO NOT STOP THE ENGINE, IT CAN BURN THE

DRIVE BELT AND/OR RUIN THE CLUTCH. CLUTCH DAMAGE CAN BE COSTLY AND IT MAY NOT

BE COVERED UNDER WARRANTY. FOR THIS REASON, IT IS IMPORTANT THAT YOU

IMMEDIATELY SHUT OFF THE MACHINE IF IT BECOMES JAMMED.

• THE CENTRIFUGAL CLUTCH ON THIS MACHINE IS PERMANENTLY LUBRICATED AND DOES NOT

REQUIRE OIL OR GREASE. IF, AFTER LONG PERIODS OF USE, THE DRUM WOBBLES

EXCESSIVELY, REPLACE THE CLUTCH ASSEMBLY. ALWAYS REPLACE SHOES AND SPRINGS IN

SETS. WHENEVER SHOES ARE CHANGED

REPLACE ALL SPRINGS.

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,

REMOVE SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Keine Kommentare

DR PRO Betriebsanleitung Seite 46